Kuhnt AS55 Series, Service Manual

Page: 90 / 173

SERVICE MANUAL AS55X
88 www.kuhnt.com 55Xseries_manual_V3.22 (18-08-15)
5.9 GSM settings
5.9.1 General

Equipped GSM channels
The amount of GSM channels, installed in the AS55X has to be set here.
Be default the amount is set of the maximum of available channels of your single
devise. If you want to use an AS551 Slave or an AS55X with a smaller amount of
channels you have to decrease or increase this value, because the AS55X do not
detect the installed modules automatically. All excessive channels will be designated
with errors.
Default value: 2 (AS550) / 6 (AS551)
Notice: Please do not use this setting to temporarily switch off GSM channels
for test purposes, because configurations to not installed channels will be
cleared. For temporarily deactivation use “GSM settings / GSM channel” (see
5.9.2)

CLIP code from PBX
If you configure CLIR in the field below (“Display number -> GSM network”), it is
possible to submit your number by entering a code in front of your dialled number.
This code you have to enter here. It can consist of up to four numeric digits.
Default value: not reported
Notice: The weighting of the CLIP settings is as follows. The lowest priority is
the setting in general GSM settings (display number -> GSM Network), then
in individual call setup, and the highest setting is the CLIP/CLIR-Code in
.General GSM settings.

CLIR code from PBX
If you configure CLIP in the field below (“Display number -> GSM network), it is
possible to suppress your visible number by entering a code in front of your dialled
number. This code you have to enter here. It can consist of up to four numeric digits.
Default value: not reported
Notice: The weighting of the CLIP settings is as follows. The lowest priority is
the setting in general GSM settings (display number -> GSM Network), then
in individual call setup, and the highest setting is the CLIP/CLIR-Code in
general GSM settings.