Disc mower
56
GMD3510-FF
Maintenance and storage
Cutterbar
Draining
From the transport position:
- Lift up the front guard.
- Remove the inner skid shoe (1) on drive side.
- Place a container of sufficient capacity under drain
plug.
- Raise cutterbar on opposite side of drain plug.
- Remove drain plug (1) and its washer.
- Allow oil to drain completely.
- Wait for dripping to stop.
- Clean and reinstall drain plug (1) and its
washer. Replace if necessary.
- Pour the correct oil quantity and quality through the
opening of the filler plug.
- Reinstall inner disk skid.
The cutterbar is lubricated for life and requires no
periodic maintenance.
If in doubt as to the oil quantity contained in
the cutterbar, fully drain and refill cutterbar
respecting recommended oil quantity and
quality.
Following all service operations or in case of
an oil leak, empty an refill cutterbar.
Before draining oil, operate the machine for a
few minutes so that the oil warms up.
The cutterbar is lubricated with 4 L (1.05 US gal) of extreme-pressure gear oil with viscosity grade
SHELL SPIRAX A and ASX 75W90 grade API.
For safety reasons, hook check chain as high as
possible.
1
1
