
Disc mower
42
GMD350 - 350-FF
Putting into service
When the following equipment is fitted:
Mechanical safety r Hydraulic pivot
Adjusting the pivot sequence of the
machine
The machine pivot sequence when putting the
machine into work/transport position is
obtained by adjusting cam (2).
- Loosen screws (1).
- Pivot cam (2) according to the required
setting.
To delay the machine pivot sequence, move
cam (2) counterclockwise.
To advance the machine pivot sequence, move
cam (2) clockwise.
- Tighten screws (1).
• Torque: 5 daN m (37 lbf ft).
Valve holder adjustment:
The oblong holes enable obtaining the valve
actuator disengagement with regards to the cam
when the hitch pins are at 450 mm (1’5’’) from the
ground (3).
2
1
1
1
1
Summary of Contents for GMD350
