KUHN GMD 801, Assembly & Operators Manual

Page: 16 / 48

- 14 -
- Attach the front safety bar (B) to its 3 hinges (C) with
the 5 cup square bolts (P) (M 10 x 25), 5 self-locking
nuts (O) (M 10) and 5 flat washers (Q) (Ø 11 x 24 x
2) (fig. 1).
- Then attach the pre-assembled front safety bar (B)
at (N) with 3 hexagonal screws (M 12 x 75) and self-
locking nuts (M 12) (fig. 1 and photo 2). Do not
tighten these 3 screws completely, so that the front
safety bar can still pivot.
- Next attach rear safety bar (A) with 6 round head
bolts (P) (M 10 x 25), 6 self locking nuts (O) (M 10)
and 6 flat washers (Q) (Ø 11 x 24 x 2) (fig. 1 and photo
2). At the same time attach stop rod (J) as shown in
figure 1 and photo 2, being sure to place 2 flat
washers (Q) (Ø 11 x 24 x 2) 11 x 24 x 2) under the
self- locking nuts (O). Fit 2 end plugs (Z) on rear
safety bars.
7° Safety guard assembly
The angular position of the swath wheel
compared to the cutterbar can be adapted
to working conditions enabling a regular
flow of the cut crop towards the rear.
Position the swath wheel so that maxi-
mum angle (A') (fig. J) is obtained. In
difficult working conditions (long, dense,
bent over crops) position it towards mini-
mum angle (A) (fig. J).
J
All manuals and user guides at all-guides.com
all-guides.com