KUHN CONTROLOR, Instruction Manual

Page: 14 / 36

14
Hectare output key
This key is used to display the output per hectare / hour.
Time key
Press this key to display the working time elapsed since the start key was pressed.
The clock is stopped if the tractor and control unit are switched off. Counting resumes when work restarts.
You can also stop the clock during work. Pressing the Time key once again stops the time counting function.
To restart counting, press the key again.
Distance key
This key is used to obtain the distance covered since starting up.
Motion speed key
Press this key to obtain the instant motion speed.
Turbine and cell test key
1) Turbine key
This key is used to view the rotation of the seed drill turbine, providing the turbine is fitted with a sensor (not supplied
with the control unit).
2) Cell test key
This key is used to test the cells and find any failures.
- Press key for five seconds
On the display, the arrow above the rpm symbol will disappear to show that the device is in the cell test mode.
- Move an obstacle in front of the cell so as to block off the optical beam. If the cell is operating, the control unit will
generate an audio signal and the number of the cell tested will be displayed on the display.
If, on the other hand, nothing happens, the cell must be replaced.
IMPORTANT:
before running the test, make sure that there is no dust or obstacle in the cell.