any user of the 3D Printer in case of questions or problems.
INFO
The HT500 3D Printer is an Open Source project. Any alteration, structural and design changes or
customization for test reasons, optimization and improvement are explicitly requested by
Kühling&Kühling. We would like to support you with your advancements and are looking forward
to receiving your feedback. We will always consider letting your achievements slip in to
constantly improve the HT500. However, please note that Kühling&Kühling cannot be held liable
for damages and injuries resulting from such alterations (see
Intended use
also).
Valid Version
Hardware revisions
Number of revision
from
until
v1.4.x
12-2015 current
On the type plate at the
rear side
of the HT500
you find all information to precisely identify your
3D Printer:
Serial number
Date of manufacturing
Hardware Revision¹
¹
You will also find the valid hardware revision in the
[Setup]
menu on the touchscreen.
Type plate on the rear side.
Software versions
Operating sofware:
RepRapOnRails Version v1.3.x →
Operating manual
Intended use
The HT500 3D Printer has been designed and built for printing three-dimensional workpieces of nearly
random geometries from common 2.85 mm thermoplastic filament strands.
The 3D Printer features advanced hot-ends with an extrusion temperature up to 500°C. In
combination with the heated build chamber (up to 70°C) and the heated print bed (up to 130°C), this
makes the HT500 suitable for printing a vast scope of materials. It is therefor capable of performing
regular 3D printing tasks with standard thermoplastics as well as special jobs with a variety of
technical plastics.