Chapter 2
Setup and Configuration
Use the following steps to set up and configure your fixture:
1. Unpack the fixture.
2. Install power cord cap for your location.
3. Mount the fixture upright or suspended from a standard truss.
4. Connect the fixture to a DMX controller via DMX cabling.
5. Connect the fixture to power.
6. Configure the fixture for DMX control.
Unpacking the fixture
The
LM-2013
fixture is transported in a shipping box or flight case specifically designed to
protect the product during transportation. When unpacking, inspect the fixture for physical
damage of its components. Khroma Technologies Ltd. assumes no responsibility for products
that are damaged during transport. Always transport a product in its shipping box or flight
case.
Installing a power cable cab
The
LM-2013
fixture is shipped without a power cable although it is ordered by customer.
When installing the power cord, be sure you chose Neutrik PowerCon input connector as main
power input and chose the correct cord cap for your area. Please note that our standard cores
in the mains lead are colored according to the following criteria:
• green and yellow = earth
• blue = neutral
• brown = live
Mounting the fixture
The KL-3036-PPC fixture can be mounted suspended from a support system (as a truss) or
freestanding on its base.
WARNING
This equipment is suitable for dry locations only. Do not
expose this equipment to rain or moisture.
CAUTION:
Always use a secondary safety cable when mounting this
fixture.This fixture must be installed and operated by
trained personnel only.
Mantain a minimum distance of 1 meter from a lighted
object
!
!
!
!
!
!
10
