KUDOS
REFRESHING INNOVATION IN SHOWERS
BI-SLIDER
Installation Instructions
Please read these instructions before installing, as incorrect fitting will invalidate the guarantee.
Carry out each stage before moving onto the next.
Do not dispose of packaging
, no claims for
damaged or missing parts will be accepted if the packaging has been disposed of.
If you are unsure about these instructions please contact Kudos Shower Products:
Customer Service Helpline: 01539 564040
ORIGINAL RANGE
TOOLS REQUIRED
KEY STAGES
IMPORTANT
GENERAL
- for the frame work and fixings use only warm soapy water and damp cloth/ sponge on a regular basis. After cleaning
please rinse with clean water to remove any residue.
Do not use abrasive scouring powders, chemicals or aerosol cleaners - these may result in damage to the surfaces, in particular, the
plated component parts.
See instruction below for glass cleaning advice.
CLEANING
LIFESHIELD
SILICONE
SEALANT
Check appearance of shower enclosure - any defects must be
reported to Kudos Shower Products before assembly/installation
Claims for imperfections will only be accepted prior to
assembly/installation.
Ensure the top of shower tray is level
in all
directions
Any claims made under the terms of the Lifetime Guarantee
must be reported to Kudos within 21 days of the fault occurring
Check the enclosure adjustment sizes are suitable for your
installation
Prior to tiling any, gap or crevice between the rim of the tray and
the wall must be filled with silicone sealant flush with the rim of the
tray -
s
ee Fig.1
Waterproof the walls using ceramic tiles/shower panels etc. before
installation of the shower enclosure
Fully seal between tiles/shower panels and the tray
BEFORE
installing the enclosure
-
s
ee Fig.2
Use care when drilling into the walls to avoid hidden pipes or
electric cables
FIG.1
FIG.2
Once the tray is installed but
before
the tiles are fitted any
crevice between the tray and
the walls
must
be filled with
silicone sealant flush with the
top of the tray.
Once the walls have been
tiled but
before
the
enclosure is installed, the
tiles
must
be silicone sealed
to the tray all of the way
around in one continuous
bead.
Your Kudos Product
is pre-treated with Life Shield on the inside surfaces only. While this makes cleaning the glass a lot easier and
helps prevent the build up of harmful lime-scale and soap deposits the glass still needs to be maintained on a regular basis. We
recommend the use of a detergent and aroma free glass cleaner (A 50/50 mix of Vinegar and Water works well!!) Strong detergents
and abrasives can damage the coating.
DO NOT
use abrasive cleaners or abrasive scrubbing equipment for cleaning!!
DO
use a squeegee to remove remaining droplets of water from glass after showering, any build up of residue can be removed easily
using an appropriate cleaner and agitation from soft cleaning equipment
THESE INSTRUCTIONS TO BE LEFT WITH THE CUSTOMER
?
Remove sliding door glass
?
Remove the clip-in extrusions
?
Position and level the frame work in situ
?
Drill walls and fix frame work
?
Fit the sliding door
?
Check & Adjust sliding door
?
Silicone seal the enclosure
?
Flat-Headed Screwdriver
?
Pozi-Drive Screwdriver
?
Spirit Level
?
Tape Measure
?
Silicone Sealant
?
4mm & 2.5mm Allen Key (Supplied)
?
Electric Drill
?
7mm Drill Bit (Masonry)
