Kubota ZG327A-AU, Operator'S Manual

Page: 63 / 104

PERIODIC SERVICE 46
B
Lubricating All Grease Fittings
To avoid personal injury:
A
Be sure to stop the engine and remove the key
before greasing.
Grease the following location.
B Checking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or anything sticky, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky thing, and
apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
EVERY 50 HOURS
B
Safety Devices
The Safety Devices in your machine are designed to
protect you while operating. Please check these Safety
Devices periodically - daily is best - to test function of the
Safety Devices before operation.
To avoid personal injury:
A
Do not allow anyone near the machine while
testing.
A
If the machine does not pass one of the
following tests, do not operate the machine.
See your local KUBOTA Dealer.
A Sit on operator's seat for all tests except for
Test 1.
A Check the following tests before operating the
machine.
C
Check the safety switches
Test 1 (OPERATOR NOT ON THE SEAT)
1. Securely set the parking brake.
2. Shift the PTO lever to "DISENGAGE" (OFF) position.
3. Set the motion control levers to the "NEUTRAL LOCK"
position.
4. Turn the key switch to "START" position.
5. The engine must not crank.
Test 2 (OPERATOR ON THE SEAT)
1. Do not set the parking brake. (release it from test 1)
2. Shift the PTO lever to "DISENGAGE" (OFF) position.
3. Set the motion control levers to the "NEUTRAL LOCK"
position.
4. Turn the key switch to "START" position.
5. The engine must not crank.
Test 3 (OPERATOR ON THE SEAT)
1. Securely set the parking brake.
2. Shift the PTO lever to "DISENGAGE" (OFF) position.
3. Grasp the motion control levers and move then inward
from "NEUTRAL LOCK" position to "NEUTRAL"
position and then release the levers.
4. Turn the key switch to "START" position.
5. The engine must not crank.
Test 4 (OPERATOR ON THE SEAT)
1. Securely set the parking brake.
2. Shift the PTO lever to "ENGAGE" (ON) position.
3. Set the motion control levers to the "NEUTRAL LOCK"
position.
4. Turn the key switch to "START" position.
5. The engine must not crank.
(1) Mower universal joint
(1) Spindle shaft
(2) Belt tension pulley
(3) Belt tension pivot