Kubota WSM B1710, Workshop Manual

Page: 28 / 31

G-13
B1710 · B2110 · B2410 · B2710, WSM G GENERAL
Changing Transmission Fluid
CAUTION
• Be sure to stop the engine when checking and changing the
transmission fluid.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Place an oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the transmission
cases.
3. Drain the transmission fluid.
4. After draining, screw in the drain plugs.
5. Fill new oil from filling port after removing the filling plug (2) up to
the upper notch on the dipstick (3).
6. After running the engine for a few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
■
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-8.)
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do not mix different blands oil together.
W10150550
Transmission fluid
capacity
B1710D
B2110D
B2110DB
B2410D
B2410DB
11.5 L
3.04 U.S.gals.
2.53 Imp.gals.
B2110HDB
B2410HDB
12.5 L
3.30 U.S.gals.
2.75 Imp.gals.
B2710HDB
15.5 L
4.10 U.S.gals.
3.41 Imp.gals.
(1) Drain Plug
(2) Filling Port
(3) Dipstick A : Oil level is acceptable within this
range.
a : B1710, B2110, B2410
b : B2710
KiSC issued 11, 2006 A