Kubota L47TL, Operator'S Manual

Page: 72 / 159

OPERATING THE TRACTOR 46
INTELLIPANEL(TM)
B
Changing Display Mode
1. Pressing the Display mode button cycles the
IntelliPanel(TM) through 6 different display.
2. When the key switch is set to "ON", the
IntelliPanel(TM) will return to the last display mode
used.
(1) IntelliPanel(TM) display
(2) Display mode button
Display 1:
Hour meter /
Trip meter
mode A [HOUR meter]
Total operating hours are displayed.
A
[TRIP meter]
Total operating hours, counted from the previous
resetting, is displayed.
A The hour meter indicates in 6 digits the hours the tractor
has been used; the last digit indicates 1/10 of an hour.
Refer-
ence
page
47
Display 2:
Fuel
consumption
mode
A
Average fuel consumption is measured per hour from the
previous resetting.
A Total fuel consumption is measured from the previous
resetting.
A
Hold down the Display mode button, and the setting is
reset to "0".
---
Display 3:
PTO speed
mode A The PTO speed is displayed when the PTO clutch control
switch is in "ON" position.
A
When the PTO clutch control switch is in "OFF" position,
"OFF" is displayed.
69
Display 4:
HST mode A The HST mode, Response and Throttle-UP settings get
displayed.
37
39
41
Display 5:
PM buildup
mode A Displays the PM buildup inside the DPF muffler.
A
Regeneration is needed when the 100% level has been
reached.
A The more the bar is extended to the right, the more PM
builds up.
16
Display 6:
Service
inspect
mode
A
The time elapsed since the previous engine oil change
gets displayed.
48
49
99
A
In cold weather the LCD meter response will normally be slower and the visibility be less, than in warmer weather.