Kubota L4701, Operator'S Manual

Page: 119 / 142

3. Fill with the new engine oil up to the upper notch on
the dipstick.
(See LUBRICANTS, FUEL, AND COOLANT on
page 94)
Engine oil capacity with engine oil filter
8.2 L
(8.7 U.S.qts.)
IMPORTANT :
• Use the following engine oil for the engine.
Engine oil DPF-compatible oil (CJ-4)
(1) Oil inlet
(2) Dipstick
(3) Drain plug (A) Range which engine oil level
is acceptable within
2. Replacing the engine oil filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before changing the engine-oil-filter-
cartridge.
• Allow the engine to cool down sufficiently
because the engine oil can be hot and can burn.
IMPORTANT :
• To prevent serious damage to the engine, use
only a KUBOTA genuine filter.
1. Remove the engine-oil-filter.
2. Put a film of clean engine oil on the rubber seal of
the new engine-oil-filter.
3. Tighten the engine-oil-filter quickly until it contacts
the mounting surface.
4. Tighten the engine-oil-filter by hand an additional
1/2 turn only.
After replacing the engine-oil-filter, the engine oil
normally decreases a little.
5. Make sure that the engine oil does not leak through
the seal and be sure to check the oil level on the
dipstick.
6. Then, replenish the engine oil up to the prescribed
level.
(1) Engine oil filter
3. Changing the transmission fluid,
replacing the hydraulic oil filter, and
cleaning the magnetic filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before changing the hydraulic-oil-
filter-cartridge.
SERVICE EVERY 400 HOURS PERIODIC SERVICE
L4701
115