Kubota L2674, Operator And Parts Manual

Page: 27 / 42

OPERATION
OM 0341SB74-A
23
A
DJUSTMENTS
Chain Tension Adjustment
The premature wear of the chain may be caused
by tension being too tight. It is therefore important
not to tighten chain to its maximum.
•
To adjust the tension on the drive chain,
loosen the bolt (item 1), securing the idler
sprocket to the snowblower housing.
•
To tighten the chain, lower the bolt. Leave
approximately 1/2" deflection in one span of
the chain. Retighten securely the bolt holding
the idler sprocket.
Skid Shoe Adjustment
Adjust the skid shoes so that the snowblower runs
level and according to the surface conditions so
that stones are not thrown with the snow.
Adjust both skid shoes to the same height to keep
the cutting edge level and adjust upwards for
smooth surfaces.
Loosen skid shoe bolts (item 2) and adjust
according to instructions below, and securely
tighten bolts:
Clearance between cutting edge and surface:
•
Level paved surface :
Adjust to lower holes
•
Uneven or gravel surface:
Adjust to upper holes
Manual Deflector Adjustment
Set the angle of deflection according to the
distance the snow must be thrown. To set the
deflector angle:
•
Rotate the chute as far as possible to the right.
•
Loosen the deflector knobs located on the side
of the deflector, adjust the deflector to the
appropriate angle.
•
Retighten the knobs.