Kubota L2674, Operator And Parts Manual

Page: 19 / 42

ASSEMBLY
OM 0341SB74-A
15
11. FIGURE 6: Install plastic handle (item 5)
over the rotation handle.
12. FIGURE 6: Insert assembled rotation tube
(item 1) inside the rotation worm assembly
(items 2). Align holes and insert a 10-24 x
1’’ allen socket head capscrew (item 3)
making sure the capscrew sinks in the
worm. Secure with a nylon insert locknut
(item 4).
13. FIGURE 6: Insert the rotation handle (item
6) inside the grommet and inside the
rotation tube (item 2). Select desired
length, align nearest holes and secure with
a 4mm x 80mm hairpin (item 8).
14. FIGURE 6A: Align the rotation worm
support with the rotation handle support.
Adjust the rotation worm support to make
firm the rotation worm between the rotation
handle support and the rotation worm
support and rotate freely. Tighten firmly the
two 1/4" NC x 5/8" bolts and the two 1/4"
NC serrated flange nuts (item 2).
15. FIGURE 6A: Adjust the rotation handle
support by moving it toward the chute to
engage the rotation worm between the chute
gear teeth. Tighten slightly the three 1/4" NC
x 5/8" bolts and the three 1/4" NC serrated
flange nuts (item 5).
16. FIGURE 6A: Rotate the chute completely to
the right then to the left using the rotation
handle (item 4).
a. If the chute is too hard to rotate because
the rotation worm is too much engaged
between the gear teeth, remove a little the
rotation worm from the gear teeth and
redo the steps.
b. If the chute rotate with difficulty because
the teeth do not engage or engage
incorrectly, adjust the rotation handle
support toward the chute and redo the
steps.
17. FIGURE 6A: Make sure the worm engages
completely when it reaches the end of the
chute gear. The handle is well adjusted
when the chute rotates easily without
straining. Tighten firmly the three 1/4" NC x
5/8" bolts and the three 1/4" NC serrated
flange nuts (item 5).
18. Lubricate the rotation worm.
NOTE : Adjust rotation handle position and
height to a comfortable and safe operating
position after the snowblower has been
mounted to the tractor.
NOTE : To insure the proper functioning of the
manual rotation, the handle support (fig.5, item
10) must be positioned the closest possible to
the top link mounting point of the three point
hitch while making sure it does not come into
contact with the operator's seat when the
snowblower is fully raised.
CAUTION: To avoid personal
injury, check the full lifting range of the
snowblower, to ensure that the chute
rotation handle is clear of the operator’s
area when the snowblower is in raised
position.
19. FIGURE 7: Install the hose clamp (item 1)
on the left side pf the snowblower 3 point
hitch and secure with a 3/8"NC x 1/2" bolt
and a 3/8" nylon insert locknut (items 2-3).
This hose clamp is provided to attach the
hoses of the hydraulic rotation option.