Kubota L2674, Operator And Parts Manual

Page: 24 / 42

ASSEMBLY
OM 0341SB74-A
20
Figure B
Figure C
A
NOTE: Before cutting, make sure the two
shafts intersect by at least 7 3/4" when in
working position that is when the snowblower
rests on the ground.
3. Hold the two half-shaft side by side and
locate the
"L" length between the two
center-to-center half-shaft universal joints.
Mark off the zone to be cut on both halves
opposite each half-shaft guard as shown
on Figure B.
4. Cut off inner and outer guard tubes as well
as the inner and outer telescopic sections.
5. Cut the guard a second time leaving the
same distance between the end of the
guard and the end of the shaft as existed
before. To obtain the proper distance "A"
shown on Figure C, cut the guard according
to the following table:
DISTANCE A
Male PTO Female PTO
1 3/4" 1 1/4"
6. File down tubes and remove chips.
7. Apply grease to inside of outer telescopic
section.
IMPORTANT: Work with fully guarded shafts
only!