REGULAR CHECKS AND MAINTENANCE WORK
68
B
Replacing Engine Oil Filter
1. Replace the oil filter cartridge at the same time as
doing the engine oil change.
2. Remove the cartridge with the supplied filter wrench.
3. Oil the O-ring of the new oil filter cartridge lightly. Then
tighten the oil filter cartridge by hand.
4. Fill engine oil to the specified level.
5. Let the engine run for approx. 5 min. and make sure
that the engine oil indicator lamp does not light up.
Then stop the engine and remove the key.
6. The engine oil level is reduced by the amount of the
filter capacity after the engine is started. It is necessary
to add oil.
A
Always check the oil level after having exchanged the
filter.
B
Greasing Front Attachments (without
Bucket Pin and Boom Swing Fulcrum)
To avoid personal injury:
A
First lower all attachments on the ground then
stop the engine and remove the key.
A
While greasing, take care not to step on the
bucket teeth.
A
When doing excavation work in water, generously
grease the following points. After ending work, grease
again.
Grease the marked grease nipples shown by arrows in the
illustration below.
(1) Oil filter
(1) Boom bottom linkage
(2) Arm bottom linkage
(3) Boom cylinder boss
(4) Boom cylinder pin
(5) Arm cylinder pin
(6) Bucket cylinder pin
(1) Swing cylinder boss
Summary of Contents for KX080-3
