Kubota KUBOTA RTV-XG850, Operator'S Manual

Page: 69 / 99

(1) Front A-ARM (grease fitting) (on both sides)
(1) Rear A-ARM (grease fitting) (on both sides)
EVERY 100 HOURS OR 3000 KM
Be sure to do the following servicing once every 100
hours or 3000 km, whichever comes first.
1. Checking wheel fastener torque
WARNING
To avoid serious injury or death:
• Never operate vehicle with a loose wheel bolts.
• Any time bolts are loosened, retighten to the
specified torque.
• Check all bolts frequently and keep them tight.
Check wheel bolts regularly especially when new. If
they are loose, tighten them as follows.
(1) Tightening torque (nuts)
Aluminum wheel, steel wheel: 130 to 150 N ⋅ m / 13.3 to
15.2 kgf ⋅ m / 95.9 to 110 lbf ⋅ ft
2. Checking brake pad wear
WARNING
To avoid serious injury or death:
• The machine can fall or slip from an unsafe
device or supports.
• Use a safe lifting device rated for the load to be
lifted.
• Lower the vehicle onto jack stands and block
the wheels before servicing.
Details regarding “JACK-UP POINT” can be found in a
different section.
(See JACK-UP POINT on page 56.)
1. Park the vehicle on a firm, flat and level surface.
2. Raise the vehicle with a safe devise and lower onto
the jack or other stable supports. Block the wheels
remaining on the ground to prevent the vehicle from
moving.
3. Remove the wheel nuts and the tires.
(1) Wheel nuts
EVERY 100 HOURS OR 3000 KM PERIODIC SERVICE
RTV-XG850
65