16. Once all isolators are started, torque the isolator fasteners to 200 ft-lbs. The M12 rear nuts
should be torqued to 98 ft.-lbs. The front bracket M14 fasteners should be torqued to 130 ft.-
lbs.
17. Remove the lift straps/chain and lift bolt from cab frame. Re-install the cab doors.
18. Route the main cab harness towards the battery on the tractor.
19. Route the 10GA red wire to the positive side of the battery, and connect with the provided
1/4" loop connector. Shorten wire if necessary, then solder connector to wire. Route the 10GA
black wire to the negative side of the battery, and connect with the provided 1/4" loop
connector. Shorten wire if necessary, then solder connector to wire. The cab options are
individually fused behind the switch plate.
20.
If the cab is equipped with the Jensen radio
, take the orange wire in the cab wire harness
and connect it to a 12v key switch activated source on the tractor. There is a red-white wire
going to the ignition switch, verify with a test light, then solder the orange wire directly to this
wire.
June 2021© Kubota BX80 Series ROPS Cab Installation Manual
