small clip on the end cap that must be pulled UP order to pop the shock off of the ball stud.
The
shock will release very easily when this is accomplished.
Lift the door assembly straight up and
off of the cab and put aside for now.
Take one ½” x 4
½
” hex bolt and fasten
to the mount at
the top of the b-post where a weld nut is located. Repeat for the other side.
13. Using a chain or lift strap, connect the lift bolts to an over head hoist or forklift.
14. Un-bolt the cab from the front mount and the rear shipping brackets and lift the cab off the
shipping pallet. Lift cab over tractor. Slowly lower down until the front and rear isolators
contact the mounting plates. The cab should be lowered straight down.
15
. Using one 5/8” x 3” bolt, heavy flat washer, and
flange nut for each isolator bracket. NOTE:
the heavy flat washer is used on the bottom of the isolator underneath the bracket. The RIGHT
REAR isolator needs the bolt head to be installed at the bottom.
June 2021© Kubota BX80 Series ROPS Cab Installation Manual
