Kuberg Ranger, Owner'S Manual

Page: 22 / 38

The engaging speed can be set-up by 2 adjusting bolts - one is located on the
adjustment lever on the handlebar and the other one just below the seat. When the
adjustment cable is set-up properly, the seat will engage slowly.
Check the speed of the reclining seat once every two weeks. If it’s too slow, unscrew the
adjusting bolt on the handlebar by 2 turns anticlockwise, check the speed again and
repeat this step if necessary. When finished with adjusting, tighten the securing nut to fix
the cable lenght.
If the reclining speed is too high, screw in the adjusting bolt on the handlebar by 2 turns
clockwise, check the speed again and repeat this step if necessary. When finished with
adjusting, tighten the securing nut to fix the cable lenght.
WARNING!
Do not operate your KUBERG Ranger if any damage is apparent. Immediately contact
your local retailer/distributor or KUBERG Customer Service.
WARNING!
There are no user serviceable elements incorporated into the motor, motor controller,
batteries, battery charger, throttle or wiring harness of your KUBERG electric motorcycle.
DO NOT ATTEMPT TO DISASSEMBLE OR ADJUST ANY OF THESE COMPONENTS.
Doing so may cause extensive damage to these components, will void your warranty,
and may result in danger to persons and/or property. If you cannot resolve any problem
using this owner’s manual, contact your KUBERG authorized dealer, or call the KUBERG
Customer Service for assistance.
Front wheel removal and installation
1 Make sure the power is switched off.
2 Lift the motorcycle onto a block or stand so that both wheels are off the ground.
3 Using the Allen wrench #6 loosen and remove the locking axle bolt, located on the
brake-disc side of the fork.
4 With the Allen wrench #5 loosen 4 front axle bolts, located on the bottom of the front
fork.
5 While holding the wheel,
slowly remove the axle
and both spacers.
6 Lower the wheel
carefully away from the
front fork.
22 Ranger - OWNER‘S MANUAL