Before first ride
NOTE:
If you purchased your KUBERG motorcycle at a local dealer your motorcycle may be fully
adjusted and ready to ride. If you purchased your KUBERG still in the original packing,
please carefully follow the instructions below and any supplemental instructions in order to
complete the assembly and adjustment of your KUBERG motorcycle.
Unpacking and assembly
WARNING!
Failure to properly assemble and adjust your motorcycle prior to use may result in
an accident, resulting in death, serious injury and/or damage to property. If you are
uncertain about any aspect of the assembly and adjustment of your motorcycle, seek
help from a qualified mechanic or KUBERG Customer Service.
1
With the help of another person, carefully remove your KUBERG Ranger from the box.
2
Place the motorcycle on a solid and level surface onto a block or stand so that the
rear wheel is off the ground.
3
Remove all the packing materials.
4
Using the Allen wrench #6 loosen and remove the locking axle bolt on the front brake
disc side.
5
Using the Allen wrench #5 loosen 4 front axle bolts, located on the bottom of the
front fork and slowly remove the axle and spacers.
6
Remove the transport insert from the front brake caliper. From this point on do not
push the front brake lever until the assembly is done completely.
7
Insert the front wheel and both spacers carefully into the front fork and insert the
axle. This step may require another person to help. The brake disc must slide easily
and gently between brake pads.
8
Insert and tighten the axle locking bolt (3,4 - 4,5 Nm) and tighten all 4 axle bolts (10,7
- 12,4 Nm)
9
Ensure the wheel is aligned correctly and all bolts are tight.
10
Spin the front wheel to ensure it is centered and spins freely. If not,go to page 23 and
follow the front brake adjustment instructions.
11
Using the Allen wrengch #4 adjust the brake levers positions to
suit the rider and then tighten the bolts (5 - 7 Nm).
12
Take the motorcycle off the block or stand and engage the
motorcycle stand.
13
Unpack the footrail from the packing foil and unscrew 4 bolts
and 2 nuts that will connect the footrail with the frame.
12
Ranger - OWNER‘S MANUAL
Summary of Contents for Ranger
Page 1: ...E N G L I S H O W N E R S M A N U A L ...
Page 2: ...2 Ranger OWNER S MANUAL ...
Page 37: ......
