Kuberg CROSS 2016, Owner'S Manual

Page: 36 / 48

36
OWNER’S MANUAL
The recommended charging time for a fully discharged battery is 6 hours.
The battery level indicator on the Cross’s handlebars will show the level of battery charge
The LED light on the charger will illuminate RED while charging.
The LED light on the charger will illuminate GREEN when the battery is fully charged.
CAUTION!
The battery charger supplied with your Kuberg Start is for INDOOR use only.
IMPORTANT NOTES ABOUT BATTERY CHARGING
Fully charge the batteries for at least 12 hours before using your Kuberg Start/Trial E/Cross
for the first time.
Fully charge the batteries for at least 12 hours for the first 3 charges after using your Start/
Trial E/Cross.
Fully charge the batteries for at least 12 hours after every 10 charges.
WARNING!
Do not cover the charger while charging, as this ,may cause the charger to overheat.
Avoid any contact with water or other fluids while charging the battery. If the battery, charger
or any connections become wet, immediately unplug the charger and thoroughly dry all
components.
Only charge the battery under the constant supervision of an adult. Children must not oper-
ate the charger.
Keep the charger and the motorcycle away from flammable items during charging.
Never dismantle or disassemble the supplied charger. Never use the supplied charger for any
other purpose other than charging a KUBERG Trial E motorcycle.
BATTERY REMOVAL AND INSTALLATION
During normal use, KUBERG does not recommend removing the batteries from the Kuberg Start/
Trial E/Cross. Should you need to replace the battery or remove it, KUBERG highly recommends
taking the motorcycle to a certified technician or a Kuberg dealer. If you choose to remove or
replace the battery yourself, please follow the following instructions carefully:
1
Ensure the power switch is in the off position and the magnetic kill switch plug is removed.
2
Remove the plastic bodywork side covers.
3
Undo the velcro tie straps on the sides of the battery. Carefully slide the battery connectors
off, one at a time. Note the direction and position of the batteries, and the terminal for each
wire. When reconnecting, each wire must be connected to the correct terminal.
4
Push the remaining positive and negative wires to the back of the bike, so the batteries can
be carefully lifted off and removed one by one.
5
To re-install the batteries, reverse the above procedure.