Kuberg CROSS 2016, Owner'S Manual

Page: 29 / 48

29
OWNER’S MANUAL
6
By pulling on the loose end of the brake link wire, tighten the brake arms until each brake
pad is 2 mm from the rim.
7
Re-tighten the brake link wire fixing bolt with a 5 mm Allen wrench (Allen key). Test that the
cable will not slip by pulling hard on the lever a number of times.
REAR BRAKE ADJUSTMENT – KUBERG START
All brakes need periodic adjustment. Band brakes on the Kuberg Start should only be adjusted
by a qualified service technician. If and when your brake shows any decline in efficiency or needs
adjustment, it is very strongly recommended that you take your bike to your local dealer for
maintenance. Improper adjustment of your brakes can cause poor braking and could lead to an
accident and/or injury.
FRONT AND REAR BRAKE SYSTEM
– KUBERG CROSS AND TRIAL E
GENERAL MAINTENANCE
Pad replacement: pads should be replaced if they become contaminated or have less than 0.8mm
thickness.
Before riding:
1
Check if the brake system is operating correctly
2
Check the hose for cracking wear of deformation. Replace if necessary
3
Check the pads for wear or contamination
After riding:
1
Remove any mud or contamination from the rotor slot on the caliper
2
Clean the caliper body with a cloth
At regular intervals:
1
Check the oil level in the reservoir
2
Lubricate the brake lever pivot with grease if nessecery
3
Check to make sure that all the bolts are tightened to the correct torque specifications.