Kuberg CROSS 2016, Owner'S Manual

Page: 28 / 48

28
OWNER’S MANUAL
3
Remove the chain-guard by removing the 4 bolts securing it.
4
On Kuberg Start, release the band brake cable by undoing the cable pinch bolt. Then
remove the band brake securing bolt. (Kuberg Trial E and Kuberg Cross have disc brakes
which do not require this step).
5
Loosen the axle bolts.
6
Loosen the chain adjustment nuts to the point where the wheel can be pushed forward,
and the chain slipped off to the right of the sprockets.
7
Pull back on the wheel to remove it.
FRONT BRAKE ADJUSTMENT - KUBERG START
1
Using an Allen wrench (Allen key), adjust the vertical height and rotation of each brake pad
so each pad is level and square on the rim.
2
Re-tighten each pad once it is in the correct position. (Make certain that the pads are cen-
tered on the rim and do not rub on the tire or fall below the rim.)
3
Using an Allen wrench (Allen key), loosen the cable fixing bolt.
4
Check to make certain that the cable noodle (curved pipe) is properly seated in the RH
brake arm link.
5
Check to make certain that the black rubber boot is not binding the brake link wire.