Remember that when mapping buttons, the functionality of the button is copied to the
other button, so the original button can be used normally until you map the functionality
of another button to that button.
D
ISABLING
B
UTTONS
You can disable a button by mapping it to itself. This can, for example, be useful after
mapping [up] to an action button. Do this by
holding [select]
and
pressing the button you
want to disable twice
. The led should now flash once slowly. To re-enable, do the same
procedure, the led should now flash twice to indicate that the button has been enabled.
T
URBO
F
IRE
To set up turbo fire for a button,
press and hold [select]
then
press and hold a button
until
the led flashes rapidly. Do the same procedure to disable turbo fire, the led flashes twice
slowly to indicate that turbo fire has been disabled.
T
URBO
F
IRE
S
PEED
You can change the speed of turbo fire by
pressing and holding [[start]
and then
pressing the [left trigger]
to make the turbo fire speed faster and
[right trigger]
to make
the speed slower. The status led will flash to show the speed of turbo fire. When reaching
the maximum or minimum speeds, the led will not flash.
The speed of turbo fire is saved with presets (see below).
R
ESET
D
EFAULT
S
ETTINGS
You can reset all mappings and remove turbo fire from all buttons by
pressing and holding
[[start]
and then
pressing [up]
.
S
AVING
A
P
RESET
You can save four different presets in the EEPROM of the gamepad. These presets can
later be loaded. To store the current mappings and turbo fire settings as a preset,
press
and hold [[start]
, then
press and hold one of the face buttons
. When the led lights
up, the preset has been saved. The four face buttons can hold one preset each.
L
OADING
A
P
RESET
To load a previously stored preset,
press and hold [[start]
, then
shortly press and
release a face button
with the stored preset (shorter than one second). The led should
flash once quickly to indicate that a preset has been loaded.
