KTR Kupplungstechnik
GmbH
D-48407 Rheine
S Y N T E X
®
m o u n t i n g i n s t r u c t i o n s
d e s i g n D K ( r a t c h e t )
KTR-N
sheet:
edition:
46210 E
4
4
Gezeichnet: 07.01.03 Sha/Koh Ersatz für:
Verteiler
Urheberschutz
gemäß DIN 34
Geprüft:
10.01.03 Sha
Ersetzt durch:
W
K
V
VA
M KC
Adjustment of the torque of engagement after the disassembly
Continuation:
•
The setting nut must be secured by tightening the set screw.
picture 2
Assembly feather keyway or clamping set
F
A T T E N T I O N !
Please check the bore, shaft, keyway and feather key before the assembly
concerning their dimensional accuracy.
Feather keyway:
For the axial fixing of the
SYNTEX
overload system with cylindrical finish bore (standard: ISO fit - H7)
and feather keyway (standard: DIN 6885, page 1 - JS9), there are the following possibilities.
1.
Tighten the grub screw on the feather key or the shaft.
2.
Secure the hub with an end plate and a screw. The grub screw must be removed.
Clamping set:
Please ask for the special mounting instruction for the respective clamping set.
Please consider the assembly situation.
Limit switch
Operation
The axial thrust of the shifting ring arising in the event of overload operates a mechanical limit switch
or an inductive sensor. Consequently a control operation is performed to disengage the drive.
Assembly
The sensor has to be mounted in a solid device in order to ensure a smooth operation. The sensor
should be protected against dirt and potential mechanical disorders.
Adjustment
When the overload coupling slips, the shifting ring makes an axial thrust of about 2 mm. The sensor
or limit switch, respectively, has to be mounted within this shifting range. In order to adapt the
mechanical limit switch and the shifting process to the machine, the limit switch has to be adjusted
accordingly. For that purpose the shifting process can be regulated after opening the cover plate on
the tappet.
!
C A U T I O N !
Before delivery of the machine please make absolutely sure to check the operation
of the limit switch. Please also note the operating instructions for the sensor or limit
switch, respectively. The axial thrust of the hub must not be obstructed by other
components.
