KTR Kupplungstechnik
GmbH
D-48407 Rheine
S Y N T E X
®
m o u n t i n g i n s t r u c t i o n s
d e s i g n D K ( r a t c h e t )
KTR-N
sheet:
edition:
46210 E
2
4
Gezeichnet: 07.01.03 Sha/Koh Ersatz für:
Verteiler
Urheberschutz
gemäß DIN 34
Geprüft:
10.01.03 Sha
Ersetzt durch:
W
K
V
VA
M KC
The
SYNTEX
overload system is delivered in assembled condition.
Components SYNTEX
-overload system
Component Quantity
Designation
Component
Quantity
Designation
1
1
hub
9
1
shaft lock washer
2
1
disk spring
10
1
set screw DIN 912
3
1
flange ring
11
1
grub screw DIN 916
4
1
setting ring
12
1
grub screw with tappet DIN 915
5
1
shifting ring
6
1
setting nut
13
3
half length reserve taper grooved
dowel pin DIN 1474
7
1
slide bush
14
6
round head grooved pin DIN 1476
8
1
axial needle spider
15
18
ball DIN 5401
picture 1: SYNTEX
®
DK
General mounting instructions
•
Please make sure the perfect technical condition of the
SYNTEX
overload system.
•
Before assembly and operation please check whether it is necessary to clean the components.
•
Lubricate the balls (e. g. Klüber-Microlube GL 263).
•
Please only use original components.
Adjustment of a higher torque of engagement
•
Fix the hub against twisting.
•
Unscrew the set screw in the setting nut.
•
Rotate the setting nut clockwise to the desired twisting angle with a sickle spanner (see table of
torque of engagement).
•
When the desired torque of engagement is adjusted, fix the setting nut by screwing down the set
screw on the threaded portion of the hub.
Adjustment of a lower torque of engagement
•
Fix the hub against torsion.
•
Unscrew the set screw in the setting nut.
•
Rotate the setting nut anticlockwise to the desired twisting angle with a sickle spanner (see table of
torque of engagement).
•
When the desired torque of engagement is adjusted, fix the setting nut by screwing down the set
screw on the threaded portion of the hub.
