KTR SYNTEX-NC 15, Operating And Assembly Instruction Manual

Page: 2 / 23

SYNTEX
®
-NC
Operating/Assembly instructions
KTR-N
Sheet:
Edition: 46110 EN
2 of 23
4
Please observe protection
note ISO 16016.
Drawn: 2017-02-10 Pz/Koh Replacing: KTR-N dated 2014-08-11
Verified: 2017-03-03 Pz Replaced by:
SYNTEX
®
-NC is a torque limiting, backlash-free overload system operating with positive locking
protecting adjacent components from damage.
In case of overload on the coupling the torque is considerably reduced to a lower residual torque.
SYNTEX
®
-NC is a not load-holding coupling.

In case of overload type DK (ratchet design) re-engages every 15° with the next following ball
indentation.

In case of overload type SK (synchronous design) re-engages after a rotation of 360°.
1 Technical data 3
2 Advice 7
2.1 General advice 7
2.2 Safety and advice symbols 7
2.3 General hazard warnings 7
2.4 Intended use 8
2.5 Coupling selection 8
3 Storage, transport and packaging 8
3.1 Storage 8
3.2 Transport and packaging 8
4 Assembly 9
4.1 Components of the couplings 9
4.2 Advice on remachining 10
4.3 Assembly (general) 10
4.4 Assembly of SYNTEX
®
-NC (hub design 1.0) 11
4.5 Assembly of SYNTEX
®
-NC (hub design 6.1) 11
4.6 Notes with the use of hollow shafts 12
4.7 Assembly of SYNTEX
®
-NC with ROTEX
®
GS 12
4.8 Assembly of SYNTEX
®
-NC with TOOLFLEX
®
13
5 Adjustment of torque 14
5.1 Torque setting - SYNTEX
®
-NC 14
5.2 Replacement of layering of disk springs 16
5.3 Setting diagrammes 18
5.3 Setting diagrammes 19
6 Assembly of limit switch 20
7 Breakdowns, causes and elimination 21
8 Disposal 22
9 Maintenance and service 22
10 Notes for using drive components/attachments 23
11 Spares inventory, customer service addresses 23
Table of contents