SYNTEX
®
-NC
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
46110 EN
10 of 23
4
Please observe protection
note ISO 16016.
Drawn:
2017-02-10 Pz/Koh
Replacing:
KTR-N dated 2014-08-11
Verified:
2017-03-03 Pz
Replaced by:
Components of SYNTEX
®
-NC with TOOLFLEX
®
Component/
component
assembly
Quantity
Description
Illustration 9: SYNTEX
®
-NC with TOOLFLEX
®
7
1
SYNTEX
®
-NC
(complete coupling)
!
The customer bears the sole responsibility for all machining processes performed
subsequently on unbored or pilot bored as well as finish machined coupling components
and spare parts. KTR does not assume any warranty claims resulting from insufficient
remachining.
We recommend to inspect bores, shaft, keyway and feather key for dimensional accuracy
before assembly.
Heating the SYNTEX
®
-NC (hub design 1.0) lightly (approx. 80 °C) allows for an easier
mounting on the shafts.
STOP
Touching the heated coupling or clamping hub causes burns.
Please wear safety gloves.
Please make sure the perfect technical condition of the
SYNTEX
®
-NC
overload system.
Please only use original
KTR
components (no purchased parts).
4
Assembly
4.1 Components of the couplings
4.2 Advice on remachining
4.3 Assembly (general)
