BRAKES
60
B00357-10
–
Press the brake caliper toward the brake disc to push back the brake piston and
ensure that no brake fluid runs out of the brake fluid reservoir, sucking it off if it
does.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove locking split pins
, withdraw pin
, and take out the brake linings.
–
Clean the brake caliper and brake caliper support.
B00358-10
–
Check that leaf spring
in the brake caliper and sliding plate
in the brake
caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation direction of the brake
disc.
B00359-10
–
Insert the brake linings, insert pin
, and mount locking split pins
.
Info
Make sure that the decoupling plate
is mounted on the piston side of the
brake lining.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
B00360-10
–
Add brake fluid to level
.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
with membrane
and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
Summary of Contents for SXF 350
Page 2: ......
