KTM Freeride E-XC 2019, Setup Instructions

Page: 32 / 44

4 WORK
30
4.16 Installing the KTM PowerPack
Caution
Risk of injury The KTM PowerPack is very heavy.
The KTM PowerPack must rest flush on the electric motor after installation.
–
Only lift the KTM PowerPack using the carry handle.
–
Make sure that nobody is pinched when the KTM PowerPack is removed or installed.
Note
Material damage
Components damaged or destroyed by water or dirt.
–
Before installing the KTM PowerPack, check that the battery discharge plug on the electric motor and the bat-
tery discharge socket on the KTM PowerPack are clean.
–
Check the battery discharge plug form ring.
–
Clean the battery discharge plug and the battery discharge socket without using water or compressed air if the
battery discharge plug or the battery discharge socket is dirty.
–
After cleaning, spray silicone spray onto the battery discharge plug form ring.
Preparatory work
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack
installed).
( p. 37)
Main work
–
Remove the protection cap. ( p. 20)
–
Check the battery discharge plug form ring. ( p. 20)
402145-12
–
Position the KTM PowerPack
1
in the vehicle.
Lifting strap (70029022000)
The KTM PowerPack is resting flush on the electric motor.
Info
The KTM PowerPack is very heavy. A second person
can help with installation.
–
Tighten screws
2
.
Guideline
KTM PowerPack
attachment M6 10 Nm (7.4 lbf ft)
Finishing work
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack
installed).
( p. 37)
–
Lock the seat. ( p. 22)