KTM Freeride E-XC 2019, Setup Instructions

Page: 22 / 44

4 WORK
20
4.5 Removing the protection cap
Note
Material damage Components damaged or destroyed by water or dirt.
–
Mount the protection cap after you have removed the KTM PowerPack.
F01672-10
Main work
–
Remove protection cap
1
with one hand.
Finishing work
–
Install the KTM PowerPack. ( p. 30)
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack
installed).
( p. 37)
–
Lock the seat. ( p. 22)
4.6 Checking the battery discharge plug form ring
Condition
The KTM PowerPack has been removed.
The protection cap has been removed.
F01673-10
–
Check battery discharge plug form ring
1
on the electric
motor.
» If the battery discharge plug form ring is dirty:
–
Ascertain that the discharge plug is de-energized.
(
p. 37)
–
Clean the form ring without using water or compressed
air.
–
Cover the contacts and spray silicone spray onto the
form ring.
» If the battery discharge plug form ring is damaged:
–
Change the battery discharge plug form ring.
(
p. 38)