KTM Freeride 350 2012, Setup Instructions

Page: 9 / 22

3 SETUP
7
B01170-01
–
Mount the license plate holder with the license plate lamp, turn signals, and reflec-
tor.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with connector that is marked green.
B01173-01
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-
ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. ( p. 12)
–
Install the battery. ( p. 13)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts installation instructions.
–
Apply the label included in the delivery (optional).
B01172-01
–
Mount the mirror clamps on both sides.
B01171-01
–
Mount and tighten the rear mirrors on both sides.
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Refuel. ( p. 15)
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.