KTM Freeride 350 2012, Setup Instructions

Page: 6 / 22

3 SETUP
4
3.1 Unpacking and setting up the vehicle
B01160-01
Packaging 2
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during setup, leave the protective
film on the vehicle until you have finished.
–
Remove the separate enclosure and unpack it. Check that the scope of delivery
is complete on the basis of the enclosed packing list.
–
Have a lift stand available.
Lift stand (54829055000)
–
Carefully loosen and remove the footrest bracket.
Info
An assistant prevents the motorcycle from falling over.
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
B01161-01
Package 12
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during setup, leave the protective
film on the vehicle until you have finished.
–
Remove the separate enclosure and unpack it. Check that the scope of delivery
is complete on the basis of the enclosed packing list.
–
Have a lift stand available.
Lift stand (54829055000)
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
B01162-01
–
Install the shock absorber. ( p. 8)
B01163-01
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp M8 22 Nm
(16.2 lbf ft)
Screw, bottom triple clamp M8 18 Nm
(13.3 lbf ft)
Info
The lowest milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
Position the bleeder screws toward the front.