KTM Freeride 350 2012, Setup Instructions

Page: 7 / 22

3 SETUP
5
0 0
B01036-10
–
Remove screws
1
. Remove the handlebar clamp.
–
Remove screws
2
. Remove the handlebar holders.
–
Place the handlebar holders in the required position. Mount and tighten screws
2
.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite ® 243™
Info
Position the left and right handlebar holders evenly.
B01164-01
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
–
Install the front wheel. ( p. 8)
–
Mount the handlebar cushion.
B01165-10
–
Attach connector holder
3
and the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
B01176-01
–
Remove the fuel tank. ( p. 9)
–
Position the turn signal wiring harness on the main wiring harness and secure with
cable binders.
Info
The figure shows how to route the wiring harness.
–
Connect all connectors to connector holder
3
.
–
Install the fuel tank. ( p. 10)
B01177-10
–
Insert bulb
4
, included in the separate enclosure, into the socket with the black
and violet cable colors and position in the turn signal indicator lamp
5
.