KTM F7360R6, Owner'S Manual

Page: 143 / 178

18 SERVICE WORK ON THE ENGINE
141
F01063-10
Main work
–
Remove gear oil drain plug 1 with magnet.
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug 1 with the magnet and
a new seal ring.
Guideline
Gear oil drain plug
with magnet M12x1.5 20 Nm (14.8 lbf ft)
401955-11
–
Remove filler plug
2
and fill up with gear oil.
Gear oil 0.80 l
(0.85 qt.) Engine oil
(15W/50)
(
p. 164)
–
Mount and tighten the oil filler plug.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. ( p. 140)
(All Six Days models, EXC AU)
–
Install the engine guard. ( p. 94)
18.4 Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
Preparatory work
–
Park the motorcycle on a level surface.