MAINTENANCE WORK ON CHASSIS AND ENGINE
76
–
Check the chain tension. (
600597-10
–
Loosen nut
.
–
Loosen nuts
.
–
Adjust the chain tension by turning adjusting screws
on the left and right.
Guideline
Chain tension
5 mm (0.2 in)
Turn the left and right adjusting screws
so that the markings on the left and right
chain adjusters
are in the same position relative to the reference marks
. The
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should check this setting at different
chain positions.
–
Tighten nuts
.
–
Make sure that the chain adjusters
are installed correctly on adjusting screws
.
–
Tighten nut
.
Guideline
Nut, rear wheel spindle
M25x1.5
90 Nm
(66.4 lbf ft)
Info
The wide adjustment range of the chain adjusters (30 mm (1.18 in)) enables
different secondary transmissions with the same chain length.
The chain adjusters
can be turned through 180°.
Summary of Contents for Chassis 690 SMC
