11
SERVICE WORK ON THE CHASSIS
80
601883-10
Main work
–
Loosen nut
1
.
–
Loosen nuts
2
.
–
Adjust the chain tension by turning adjusting screws
3
on the left and right.
Guideline
Chain tension
5 mm (0.2 in)
Turn the left and right adjusting screws
3
so that the markings on the left and right
chain adjusters
4
are in the same position relative to the reference marks
C
. The
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
–
Tighten nuts
2
.
–
Make sure that the chain adjusters
4
are installed correctly on adjusting screws
3
.
–
Tighten nut
1
.
Guideline
Nut, rear wheel spindle
M25x1.5
90 Nm
(66.4 lbf ft)
11.19
Check the chain, rear sprocket, engine sprocket, and chain guide
Preparatory work
–
Raise the motorcycle with the rear wheel stand. (
