7
HANDLEBAR, CONTROLS
33
7.1
Handlebar position
401454-11
On the upper triple clamp, there are 2 holes at a distance
A
to each other.
Distance
A
between holes
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance
B
from the center.
Distance
B
between holes
3.5 mm (0.138 in)
The handlebar can be mounted in 4 different positions. In this way, the handlebar can
be installed in the position most comfortable for the rider.
7.2
Adjusting handlebar position
401454-10
–
Remove the four screws
1
. Remove the handlebar clamp. Remove the handlebar
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
2
. Remove the handlebar support.
–
Place the handlebar support in the required position. Fit and tighten the two
screws
2
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Fit and evenly tighten the four screws
1
.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
7.3
Checking the routing of the throttle cable
Preparatory work
–
Remove the seat. (
p. 62)
–
Take off the side cover. (
p. 63)
