SERIAL NUMBER LOCATIONS
»
ENGLISH
5
Chassis number
The frame number is stamped on the right side of the steering head tube.
Write this number into the relevant box on page 1.
Engine number, engine type
The engine number and engine type are stamped on the right hand side of
the engine below the engine sprocket. Write the number into the box on
page 1.
Clutch lever
The clutch lever
[1]
is fitted on the left hand side of the handle bar. The adjust-
ing screw
[A]
is used to change the original position of the clutch lever (see
maintenance work on chassis and engine).
The clutch is hydraulically actuated and adjusts itself automatically.
Hand decompression lever
The hand decompression lever
[2]
is only used in two special cases:
a) When the engine stalled.
It is possible that the starter motor is not able to crank the engine on the
next attempt. This is due to the fact that the automatic decompressor does-
n’t work properly. If this happens, pull the manual decompression lever
and start again. Afterwards normal starting will be possible.
b) When you want to push the motorcycle.
While pushing, pull the hand decompression lever to make it easier to get
the engine going.
Choke lever
When the choke lever
[3]
is pulled backwards, a bore is opened in the carbu-
retor which enables the engine to draw in additional fuel. This produces a
„rich“ fuel/air mixture necessary for cold start. When the choke lever is pushed
forward as far as it will go, the bore will be closed again. In this position the
choke cable must have a play of approx. 2 mm.
OPERATION INSTRUMENTS
»
3
2
1
A