ENGLISH
36
TROUBLE
Engine does not rev high
Engine will not reach full
power
Engine stops or splutters in
carburettor
Engine gets to hot
High oil consumption
All switched on lamps blown
out
Horn, flasher lights, and
E-starter do not work
The battery is discharged
CAUSE
Carburettor fuel level too high
because float needle valve is dirty
or worn out
Loose carburettor jets
Electronical ignition timing faulty
Fuel supply partically interrupted or
carburettor dirty
Float leaks
Air filter very dirty
Exhaust system is not tight, defor-
med, or the silencer contains not
enough glass fiber yarn
Valve gap to small
Loss of compression because hand
decompressor has no play
Electronical ignition timing faulty
Insuffient fuel
Engine takes air out of control
Insufficient cooling liquid
Not enough air stream
Cooling system has not been bled
Radiators very dirty
Foam formation in cooling system
Bent cooling hose
Thermostat defective
Hose of engine ventilation is bent
Engine oil level too high
Motor oil too thin (viscosity)
Capacitor or voltage regulator
faulty
Blown fuse in the starter relay
The battery isn’t charged by the
generator because
REMEDY
Dismount carburettor and check if worn out
Tighten jets
Have ignition system checked
Clean and check fuel system as well as carburettor
Replace the float
Clean or replace air filter
Check if exhaust is damaged, replace glas fibre yarn in exhaust
silencer
Adjust valve gap
Check setting of the hand decompression cable
Have ignition system checked
Clean and check fuel system and carburettor
Check rubber sleeve and carburetor for tight fit
Refill cooling liquid (see maintenace work), check cooling
system for leaks
Drive on briskly
Bleed cooling system
Clean radiators with water jet
Replace cooling liquid, use anti freeze liquid with brand name
Shorten or replace cooling hose
Dismount and check thermostat (opening temperature 70°C,
(158°F) or replace it
Dislocate i.e. replace non-buckling vetilation hose
Check engine oil level and, if necessary, correct it
Use thicker engine oil; see chapter „Engine oil“
Dismount seat and fuel tank and check connections, have
capacitor and voltage regulator checked
Dismount left side paneling and filter box cover, replace fuse
Remove seat and fuel tank and check voltage regulator
connections; voltage regulator and generator should be
checked by a KTM dealer.
