ENGLISH
20
Mount the right brake pad and fix it with the bolt. Mount the left brake pad
and insert the bolt until it stops. Mount the clips.
When mounting the brake pads, be sure to check for correct fit of the
sliding metal-sheet
6
in the caliper support and of the leaf spring
7
.
WARNING
– I
T IS VERY IMPORTANT TO KEEP THE BRAKE DISK FREE FROM OIL AND FATTY MATTERS
.
O
THERWISE
,
THE BRAKING EFFECT WOULD BE STRONGLY REDUCED
.
– A
FTER ASSEMBLY
,
CHECK IF CIRCLIPS HAVE BEEN FITTED CORRECTLY
.
– H
AVING PERFORMED ANY WORK ON THE BRAKING SYSTEM
,
ONE MUST ALWAYS
ACTUATE THE HAND BRAKE LEVER OR FOOT BRAKE LEVER
,
RESPECTIVELY SO AS TO
ENSURE THAT THE BRAKE PADS WILL LIE AGAINST THE BRAKE DISK AND THE PRESSURE
POINT IS ESTABLISHED
.
Changing the basic position of the foot brake pedal *
The basic position of the foot brake pedal can be altered by turning the stop
screw
1
. The free play at the foot brake pedal must then be adjusted by
means of the piston rod
2
.
Measured on the outside, the foot brake pedal must have 3-5 mm
(0.12–0.20 in) of free play, before the piston rod can move the piston in the
brake cylinder (to be recognised from the resistance on the foot brake
pedal).
!
CAUTION
!
I
F THIS FREE PLAY IS NOT PRESENT
,
THEN PRESSURE CAN BUILD UP IN THE BRAKE SYSTEM
WHEN DRIVING
,
CAUSING THE REAR WHEEL TO BRAKE
.T
HE BRAKING SYSTEM OVERHEATS
AND MAY EVEN FAIL COMPLETELY IN EXTREME CASES
.
Checking rear brake fluid level
The reservoir for the rear disc brake is disposed on the engine in the vicinity
of the oil filters. The brake fluid level must not drop below the „MlN” mar-
king when the vehicle is in an upright position.
WARNING
I
F THE BRAKE FLUID LEVEL DROPS BELOW THE MINIMUM EITHER THE BRAKE SYSTEM HAS A
LEAK OR THE BRAKE PADS ARE COMPLETELY WORN
. I
N THIS CASE
,
CONSULT AN
AUTHORIZED
KTM
DEALER IMMEDIATELY
.
Refilling the rear brake fluid reservoir *
When the brake fluid level has dropped to the MIN mark, you need to refill
the brake fluid reservoir.
This is done by first unscrewing the cap
3
and rubber bellows
4
. Add
brake fluid DOT 5.1 (Shell Advance Brake DOT 5.1) until it reaches the
MAX mark, then screw rubber bellows and cap back on. Rinse off spilled or
overflowing brake fluid with water.
WARNING
– N
EVER USE
DOT5
BRAKE FLUID
! I
T IS BASED ON SILICONE OIL AND OF A PURPLE
COLOR
. S
EALS AND BRAKE HOSES MUST BE ESPECIALLY ADAPTED TO IT
.
– S
TORE BRAKE FLUID OUT OF REACH OF CHILDREN
.
– B
RAKE FLUID CAN CAUSE SKIN IRRITATION
. A
VOID CONTACT WITH SKIN AND EYES
.
I
F YOU GET BRAKE FLUID IN YOUR EYES
,
RINSE WITH PLENTY OF WATER AND CONSULT
A DOCTOR
.
!
CAUTION
!
– D
ON
’
T LET BRAKE FLUID GET IN CONTACT WITH PAINT
,
IT IS AN EFFECTIVE PAINT
REMOVER
.
– U
SE ONLY CLEAN BRAKE FLUID TAKEN FROM A TIGHTLY SEALED CONTAINER
.
6
7
4
5
3-5mm
3
4
5
1
2
3
