KTM 450 XC-W SIX DAYS USA, Setup Instructions

Page: 5 / 16

SET
‑
UP
3
2.1
Unpacking and setting up the vehicle
800030-10
Packaging 2
–
Remove the box and the plastic packaging.
Info
To avoid damaging the motorcycle during assembly, leave the protective
film on the vehicle until you have finished.
–
Take out the separate enclosure and unpack it. Check its contents on the basis
of the enclosure list.
–
Set up the work stand.
Work stand (54829055000)
–
Carefully loosen and remove the tensioning belt over the link fork.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a work stand.
–
Check the vehicle for transport damage.
600811-10
Packaging 12
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during assembly, leave the protective
film on the vehicle until you have finished.
–
Take out the separate enclosure and unpack it. Check its contents on the basis
of the enclosure list.
–
Set up the work stand.
Work stand (54829055000)
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a work stand.
–
Check the vehicle for transport damage.
B00148-01
–
Install the shock absorber. ( p. 9)
600814-10
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.