KTM 450 XC-W SIX DAYS USA, Setup Instructions

Page: 7 / 16

SET
‑
UP
5
600819-10
(All XC
‑
W models)
–
Attach the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
–
Connect the connector.
800042-10
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Plier for footrest spring (58429083000)
–
Remove the protective plastic.
–
Install the front fender. ( p. 8)
–
Install the front wheel. ( p. 6)
800035-10
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ven-
tilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a doctor.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. ( p. 7)
–
Install the battery. ( p. 8)
–
Unpack the KTM PowerParts (optional) contained in the delivery and install them.
Info
Read the accompanying KTM PowerParts installation instructions.
–
Attach the stickers contained in the delivery (optional).
(all EXC models)
–
Mount and tighten the rear mirror adapter and rear mirror on both sides.
–
Exactly position all controls on the handlebar. Tighten all screws.
–
Mount the reflector.
–
Refuel. ( p. 8)
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.