KTM 450 SX-F EU 2014, Setup Instructions, Page: 7 / 17

2 SETUP
5
101018-01
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. ( p. 7)
–
Install the front wheel. ( p. 7)
–
Correctly mount the fuel tank breather.
C00138-01
–
Mount the handlebar cushion.
–
Install the start number plate. ( p. 8)
101019-01
–
Mount the footrests with the springs and pins. Secure the pins using the washers
and cotter pins.
Pliers for footrest spring (58429083000)
800035-10
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in
well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. ( p. 9)
–
Install the battery. ( p. 8)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying
KTM PowerParts
fitting instructions.
–
Apply the label included in the delivery (optional).
–
Refuel. ( p. 11)
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.