15
ELECTRICAL SYSTEM
98
15.11
Changing the turn signal bulb (All EXC
‑
F models)
Note
Damage to reflector
Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
101722-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
.
–
Lightly squeeze orange cap
in the area of the holding lugs and take it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
15.12
Changing the speedometer battery
Preparatory work
–
Remove the headlight mask with the headlight. (
K00122-10
Main work
–
Remove screws
.
–
Pull the speedometer upward out of the holder.
K00123-10
–
Using a coin, turn protection cap
all the way counterclockwise and remove it.
–
Remove speedometer battery
.
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
Summary of Contents for 250 EXC-F EU 2010
Page 2: ......
