KTM 250 EXC-F AUS, Owner'S Manual

Page: 82 / 117

ELECTRICAL SYSTEM
80
13.10
Checking the headlight adjustment
0 0 A A
0 0 B B
400726-10
–
Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically at a distance

in front of the wall.
Guideline
Distance

5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight adjustment.
The border between light and dark must be exactly at the lower mark when the
motorcycle is operational and complete with rider.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 80)
13.11
Adjusting the headlight range
–
Check the headlight adjustment. ( p. 80)
301251-10
–
Loosen screw

.
–
Adjust the headlight range of the headlight by moving it up or down.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (mark is applied under: Checking the headlight setting).
Info
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw

.
13.12
Changing the speedometer battery
–
Remove the headlight mask with the headlight. ( p. 78)
100859-10
–
Remove screws

.
–
Pull the speedometer out of the bracket from above.
100860-10
–
Using a coin, turn locking cap

counterclockwise all the way and remove it.
–
Remove speedometer battery

.
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) ( p. 102)
–
Check that the O-ring of the locking cap is seated properly.