SERVICE WORK ON THE CHASSIS
45
10.10
Installing the fork protector
x
600878-10
–
Position the fork protection on the left fork leg. Mount and tighten screws
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Install the fork legs.
x
10.11
Removing the lower triple clamp
x
(EXC
‑
F Factory Edition, EXC
‑
F SIX DAYS, XCF
‑
W SIX DAYS)
–
Remove the fork legs. (
–
Remove the front fender. (
500099-10
–
Remove screws
and hang the CDI control unit to the side.
Info
Do not unplug the CDI control unit.
–
Remove screw
. Remove screw
, take off the top triple clamp with the handle-
bar and set it aside.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
500100-10
–
Remove O-ring
. Remove protector ring
.
–
Remove the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
10.12
Installing the lower triple clamp
x
(EXC
‑
F Factory Edition, EXC
‑
F SIX DAYS, XCF
‑
W SIX DAYS)
0
0
2
2
0
0
1
1
0
0
3
3
500098-10
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
is correctly positioned.
–
Push up protective ring
and O-ring
.
