KTM 125, Repair Manual

Page: 20 / 159

Adjusting oil pump (only with separate lubrication)
NOTE: Prior to adjusting the oil pump, you have to check and, if
necessary, adjust the clearance of the throttle cable.
– Loosen the 3 bolts
1
of the oil pump housing and remove the oil
pump cover
2
. To make adjustment and control easier, loosen the
bolts of the intake flange
3
, remove 4 of them and move the flange
sidewards.
– If the oil pump has been adjusted correctly, the mark
A
must coincide
with the notch
B
on the cable pulley (except 125 EXE and 125
Supermoto).
– On 125 EXE- and 125 Supermoto-models the notch B must coincide
with the edge C .
! CAUTION !
I
F THE ADJUSTMENT OF THE OIL PUMP IS NOT CORRECT
,
THE ENGINE IS NOT SUPLIED
WITH THE CORRECT AMOUNT OF OIL AND THIS CAN RESULT IN ENGINE DAMAGE
.
– If necessary, loosen the lock nut
4
, and correct the adjustment by
turning the adjusting screw
5
as required.
– Following the adjustment procedure, the lock nut has to be tightened
again.
– Mount cover
2
and flange
3
, tighten the 2 bolts.
2-5C
4
5
1
2
3
A
B
B
C