-33-
DHCP Enabled
Use DHCP to get dynamic IP address configuration for the device
Fallback IP Address
IP address used when DHCP mode is not enabled
Fallback Subnet Mask Subnet mask for IP address used when DHCP mode is not enabled
Fallback Gateway
Default gateway IP address used when DHCP mode is not enabled
Management VLAN
Set management VLAN information (See next section)
- VID
VLAN ID configured for web management to the device
- CFI
CFI value for web reply packets from the device
- User priority Priority value for web reply packets from the device
Name
Set the system name for this switch unit
Note: It is suggested to give each device unit a system name as an alternative unique
identification beside IP address.
Password
Set new password
Inactivity Timeout
Timeout for auto logout (unit: second)
SNMP enabled
Enable SNMP agent
SNMP Trap destination The IP address of the SNMP trap manager
SNMP Read community The community allowed for the SNMP [get] message
SNMP Write community The community allowed for the SNMP [set] message
SNMP Trap community The community used for the SNMP trap messages sent by the switch
802.1Q Control
802.1Q Control function main configuration
Disable - all packets are allowed to pass with no 802.1Q control.
Enable - 802.1Q control mechanism is activated for the conversion.
Jumbo Mode
Enable / disable Jumbo mode to support jumbo packets
Disable - support maximum packet size up to 1526 bytes
Enable - support maximum packet size up to 8000 bytes
Link fault pass through Enable / disable link fault pass through function
Remote TP auto report
Enable / disable remote TP port link status function
Power Saving Mode
Enable / disable power saving function
Apply
Click to apply the changes.
Refresh
Click to refresh the page. Any changes made locally will be undone.
4.4.1 Management VLAN
Management VLAN settings allow administrator to access the device and perform the web management over a
dedicated VLAN only.
The following rules are applied with the Management VLAN:
